Nails For Roof Shingles
- Extra large headed clout nails
- 20mm long
- 500g enough for 5 packs roof shingles
You will need extra large headed clout nails to fix down your each shingle strip. Extra large headed clout nails are usually about 10mm in diameter. When they are nailed into the roof this large head creates a protective cover for the hole you created as the nail went in. If you use a smaller headed nail then there is less protection. A pin head nail will not provide any protection.
It is important to use nails as opposed to staples. If you use staples, even with a handheld hammer tacker, you have to use a lot of force to drive the staples in. This can cause the staples to rip the surface of the roof shingle allowing water and there is no protective barrier to stop water getting to the holes you created as the staple went in.
It is also best to manually hammer the nails in. When you work manually you are totally in control of the angle, how much force you use and how far you hammer them down. If the nails go in too far or on an angle the head of the nail will tear the surface of the shingles and allow water penetration.
You will need to measure the thickness of your roof boards before ordering to make sure 20mm is going to be long enough to go through 2 layers of roof shingles and a good distance into the roof boards.
If you only have thin roof boards you might need shorter nails, you should be able to purchase these in a local DIY store.
You may need a small bag of longer nails for the ridge where you can be going through more layers, again you should be able to find them in a local DIY store.
If you have more than 5 packs of roof shingles we also sell 1kg bags.
Please contact us if you have any questions